[Tuto] [EN/FR] Install nLoader / TI-Nspire CX

→ **MyCalcs** profile · by **Ti64CLi++** » 24 Apr 2018, 18:44

Yes you'll need to reset minOS, each time you want to switch

→ **MyCalcs** profile · by **critor** » 24 Apr 2018, 18:44

If you hot-switch to an older version and forget to reset minOS, the new OS is going to be removed on the next boot.

→ **MyCalcs** profile · by **frank1905** » 24 Apr 2018, 19:00

Okay, thank you all!

→ **MyCalcs** profile · by **critor** » 24 Apr 2018, 19:20

You're welcome.

→ **MyCalcs** profile · by **Shirotaku** » 03 May 2018, 15:47

frank1905 wrote:when i try to reset it says that the calculator had been modified to enable CAS, then the red cross appears and there's the stuck loading bar.

hello,

I got the same error like frank.

Accessing the diag or maintenance menu doesn't work. Maintenance menu is not showing up at all and diag sometimes tells me, that there is no OS installed, or it brings up the grey screen with the clock (freezed) and then it reboots after a few seconds.

PS: It could be that I used old files from another tutorial <.< (Hope this helps you)

→ **MyCalcs** profile · by **critor** » 03 May 2018, 18:42

Shirotaku wrote:Accessing the diag or maintenance menu doesn't work. Maintenance menu is not showing up at all and diag sometimes tells me, that there is no OS installed, or it brings up the grey screen with the clock (freezed) and then it reboots after a few seconds.

It doesn't make any sense, sorry.

→ **MyCalcs** profile · by **Shirotaku** » 03 May 2018, 19:52

critor wrote:
Shirotaku wrote:Accessing the diag or maintenance menu doesn't work. Maintenance menu is not showing up at all and diag sometimes tells me, that there is no OS installed, or it brings up the grey screen with the clock (freezed) and then it reboots after a few seconds.

It doesn't make any sense, sorry.

But that's, whats happening

→ **MyCalcs** profile · by **critor** » 03 May 2018, 20:09

Totally impossible, sorry.

Maybe taking and sharing pictures would be a better idea.

→ **MyCalcs** profile · by **Shirotaku** » 03 May 2018, 20:28

Normal StartUp (+try to access maintenance menu (

)):

"Diag-Menu" (

):

I couldn't manage to get the green screen with the clock. (I think, this happened, when I tried to reinstall the OS)

→ **MyCalcs** profile · by **critor** » 03 May 2018, 20:37

Ok, this looks clearer to me, thank you very much.

Well apparently, you flashed a wrong image in the Boot2 partition.

By using the Diags combo, you should be able to install an OS and then resume the tutorial at step D.
In this context, nLoader won't be enabled. So you need to install a non-CAS OS for now.