Hello,
I know I had my Nspire CX working as a CAS model (on an older version)
but after going back to CX I don't seem to get it to work as a CAS again.
When setting the calc type to CAS in the ControlX boot menu (Ctrl+Reset, 8, 0)
my new settings are NOT saved and the calc boots normally.
Installed Versions:
OS: CX 4.5.4.48
CtrlX: 5.0.3
Boot: 4.50.14
My hardware is CR.
What am I missing?
Regards, Lars
Problem with setting CX as CAS (nBoot & ControlX)
First unread post • 3 posts
• Page 1 of 1
-
ibimslawa
Niveau 0: MI (Membre Inactif)- Posts: 1
- Joined: 01 Apr 2024, 22:46
- Gender:
- Calculator(s):→ MyCalcs profile
- Class: University
Re: Problem with setting CX as CAS (nBoot & ControlX)
you need boot2 4.4.0.8 , boot1.5 4.4.0.8 , use btmg put them in boot2 area , then ctrl+reset,ctrl+0,ctrl+8
Last edited by Maticalrock on 07 Apr 2024, 12:44, edited 1 time in total.
-
Maticalrock
Niveau 2: MI2 (Membre Initié)- Posts: 12
- Joined: 04 Apr 2024, 16:04
- Gender:
- Calculator(s):→ MyCalcs profile
-
Maticalrock
Niveau 2: MI2 (Membre Initié)- Posts: 12
- Joined: 04 Apr 2024, 16:04
- Gender:
- Calculator(s):→ MyCalcs profile
3 posts
• Page 1 of 1
Return to Problèmes divers / Aide débutants
Who is online
Users browsing this forum: No registered users and 30 guests