TI-Nspire Bricked

[JayThePro]

Hello. I do not know if this is the right section, but I have an important question. I installed nLaunch using the switchpack, and everything was going fine for several weeks(2?). Today, I was switching from the CAS os I had installed to the regular OS, and my calculator got stuck in an infinite loop. I backed it up, and formatted it. I think this was a huge mistake. I then proceeded to install OS 3.6550, and it has stopped working. Any workarounds, or is my TINSPIRE CX bricked? Thanks. The boot code is 3.24 Thanks in advanced!

[Levak]

What is _exactly_ its current state ?

[JayThePro]

Thanks for the fast reply! I'll start from the beginning, as I wasn't clear in my before post. Today in math, we were practicing for upcoming state exams. I began to switch from the CAS v3.1 OS to the Non-Cas v3.6, renaming the phoenix.old to phoenix. After I did that, I accidentally clicked for the calculator to "run" phoenix. It failed, due to obvious reasons. I then reset the calculator, and it got stuck in and infinite loop, stopping at the screen of the timer on the "chains". The clock doesn't spin at all. I knew something was wrong, and turn it off. About an hour ago, I backed up my documents, and formatted the whole thing. I then began to install the Non-Cas OS 3.6 in hopes of a turnaround. It failed, and the calculator doesn't get past the spinning clock. That is it's current state.

[Levak]

Launch the diagnostic menu and then reboot, it will solve all your problems.

[JayThePro]

How Exactly?

[Legimet]

Hold down the reset button and + + at the same time. While holding these down, release the reset button.

[JayThePro]

Nevermind, I figured it out. Thank you!

[jaroslavN]

what i need to do next

[critor]

What are you trying to achieve ?