Anyone else know about this?
It could indeed be used to cheat in certain cases. Basically, if you hold down the reset button for 3 seconds while the calculator is turned off in Press-To-Test, the LED light will stop blinking. As if the calculator goes into a deep sleep mode.
Éteindre le LED en mode Press-To-Test
Voir le premier message non lu • 2 messages
• Page 1 sur 1
Éteindre le LED en mode Press-To-Test
de cxcas8272019 » 27 Aoû 2019, 12:12
-
cxcas8272019 
Niveau 0: MI (Membre Inactif)- Messages: 1
- Inscription: 27 Aoû 2019, 11:58
- Genre:
- Calculatrice(s):→ MyCalcs profile
Re: Éteindre le LED en mode Press-To-Test
de Adriweb » 27 Aoû 2019, 12:20
Yes.
(The "Deep Sleep" mode is actually called Ship mode, because it's what is used when the calcs get shipped, in order to reduce battery consumption to a minimum)
(The "Deep Sleep" mode is actually called Ship mode, because it's what is used when the calcs get shipped, in order to reduce battery consumption to a minimum)
MyCalcs: Help the community's calculator documentations by filling out your calculators info!
MyCalcs: Aidez la communauté à documenter les calculatrices en donnant des infos sur vos calculatrices !
Inspired-Lua.org: All about TI-Nspire Lua programming (tutorials, wiki/docs...)-
AdriwebAdmin 
Niveau 16: CC2 (Commandeur des Calculatrices)- Messages: 14616
- Images: 1218
- Inscription: 01 Juin 2007, 00:00
- Localisation: France
- Genre:
- Calculatrice(s):→ MyCalcs profile
- Twitter/X: adriweb
- GitHub: adriweb
2 messages
• Page 1 sur 1
Retourner vers Problèmes divers / Aide débutants
Qui est en ligne
Utilisateurs parcourant ce forum: Aucun utilisateur enregistré et 68 invités
