Change keyboard and screen of a ti-nspire cx

[Federico Di Ceglie]

Perfect, thank you very much indeed

[Federico Di Ceglie]

Critor, another question, can i do the same thing between a ti-nspire cx and a ti-nspire cx cas?

[critor]

Yes, you can swap the screen, keys, and keys contacts sheet between a CX and a CX CAS.

[Federico Di Ceglie]

Perfect, thanks

[Federico Di Ceglie]

Good morning Critor, sorry to bother you but I'm trying to remove the screen frame. Do you have any advice for me to do this? Is there a risk of breaking something?
Thanks
Federico

[critor]

Damaging/breaking/cracking the frame is far from being impossible, especially in its lower part which is weaker because of the keys.

I have no perfect method so far for such a recent CX.

I usually try to insert a thin item to slightly unstuck the frame at a corner, in red below :

[Federico Di Ceglie]

I was wondering even if screws hidden under the screen frame were screwed on the frame and, pulling, I could tear the plastic

[critor]

No, the frame isn't screwed.

[Federico Di Ceglie]

Ok, thank you very much. I'll try with your method

[Federico Di Ceglie]

I managed to remove the screen frame, it was difficult but not so much. The two hidden screws are not Torx T6, are smaller. Are very small