Page 1 of 3

Red screen. Need some help!

PostPosted: 20 Dec 2019, 05:28
by vhrks
I tried doc ee enter, but there is some battery problem i think.

So I tried esc menu minus, but it didnt work. I think diagnose software died also.

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 14:00
by Extra44
Maybe :
First, try to charge the device (for me, it take a complete night)

And then see if it answer the same thing !

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 15:04
by critor
You can't invoke maintenance menu with a low battery.

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 15:20
by Hamza.S
Il peut tenter le diagnostic pour recharger la batterie en attendant non ?

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 15:40
by Extra44
Hamza.S wrote:Il peut tenter le diagnostic pour recharger la batterie en attendant non ?

I think The problem is :his battery is low.
He can do charging his battery, and after a while try to use diagnostic menu.

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 16:12
by critor
vhrks wrote:I tried doc ee enter, but there is some battery problem i think.

So I tried esc menu minus, but it didnt work. I think diagnose software died also.


:nses: :nsme: :nsmo: should bring up the ControlX menu.
From the ControlX menu, it's possible to launch the Diags software.

Holding :nsct: should also trigger the ControlX menu.

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 17:27
by vhrks
critor wrote:
vhrks wrote:I tried doc ee enter, but there is some battery problem i think.

So I tried esc menu minus, but it didnt work. I think diagnose software died also.


:nses: :nsme: :nsmo: should bring up the ControlX menu.
From the ControlX menu, it's possible to launch the Diags software.

Holding :nsct: should also trigger the ControlX menu.


https://www.reddit.com/r/nspire/comment ... urce=share

can you check the video?

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 17:34
by critor
Yes, thanks.

Apparently ControlX doesn't work anymore.

Do you remember your OS version ?

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 18:28
by vhrks
critor wrote:Yes, thanks.

Apparently ControlX doesn't work anymore.

Do you remember your OS version ?


Few months ago (when the calculator works fine) shen I voot my ti, some.pop up says "constrol X 4.5.0" this means 4.5.0 right? And back of the calc, xxxxxx P-0911D. Some says if you want to install ndless, the letters are important. Right?

Re: Red screen. Need some help!

PostPosted: 20 Dec 2019, 18:34
by critor
Hardware Revision D is ok.

But do you remember the calculator Operating System version ? 4.5.0 ? 4.5.1 ? 4.5.2 ?...
Did you install the latest 4.5.2 version ?

Could you explain what you did before the red screen appeared for the first time ?

Thanks.