Page 1 of 1

Éteindre le LED en mode Press-To-Test

Unread postPosted: 27 Aug 2019, 12:12
by cxcas8272019
Anyone else know about this?



It could indeed be used to cheat in certain cases. Basically, if you hold down the reset button for 3 seconds while the calculator is turned off in Press-To-Test, the LED light will stop blinking. As if the calculator goes into a deep sleep mode.

Re: Éteindre le LED en mode Press-To-Test

Unread postPosted: 27 Aug 2019, 12:20
by Adriweb
Yes.
(The "Deep Sleep" mode is actually called Ship mode, because it's what is used when the calcs get shipped, in order to reduce battery consumption to a minimum)