Hi
I have cas software installed on my nspire but it is with nlauch doing dualboot
My question is if It is possible to convert my ti nspire cx p-0711c to cx cas by flashing with nsnandmanager diag.img manuf.img and boot2.img from a cx cas unit with the same reviocion has mine (p-0711C) ????
Thanks
Fully converte ti nspire cx to cx cas
Voir le premier message non lu • 2 messages
• Page 1 sur 1
-
joaospeed100
Niveau 2: MI2 (Membre Initié)- Messages: 8
- Inscription: 18 Juin 2014, 20:56
- Genre:
- Calculatrice(s):→ MyCalcs profile
- Classe: 11
Re: Fully converte ti nspire cx to cx cas
Hi,
I don't think it's possible. diag.img, manuf.img and boot2.img are common files for CXs and CX CASs.
The only solution is to install nlaunch.
I don't think it's possible. diag.img, manuf.img and boot2.img are common files for CXs and CX CASs.
The only solution is to install nlaunch.
-
Hamza.SAdmin
Niveau 17: GM (Grand Maître des calculatrices)- Messages: 4464
- Images: 18
- Inscription: 07 Nov 2014, 00:43
- Genre:
- Calculatrice(s):→ MyCalcs profile
2 messages
• Page 1 sur 1
Retourner vers Problèmes divers / Aide débutants
Qui est en ligne
Utilisateurs parcourant ce forum: Aucun utilisateur enregistré et 41 invités