Forum TI-Planet.org

Hello. I do not know if this is the right section, but I have an important question. I installed nLaunch using the switchpack, and everything was going fine for several weeks(2?). Today, I was switching from the CAS os I had installed to the regular OS, and my calculator got stuck in an infinite loop. I backed it up, and formatted it. I think this was a huge mistake. I then proceeded to install OS 3.6550, and it has stopped working. Any workarounds, or is my TINSPIRE CX bricked? Thanks. The boot code is 3.24 Thanks in advanced!

What is _exactly_ its current state ?

Thanks for the fast reply! I'll start from the beginning, as I wasn't clear in my before post. Today in math, we were practicing for upcoming state exams. I began to switch from the CAS v3.1 OS to the Non-Cas v3.6, renaming the phoenix.old to phoenix. After I did that, I accidentally clicked for the calculator to "run" phoenix. It failed, due to obvious reasons. I then reset the calculator, and it got stuck in and infinite loop, stopping at the screen of the timer on the "chains". The clock doesn't spin at all. I knew something was wrong, and turn it off. About an hour ago, I backed up my documents, and formatted the whole thing. I then began to install the Non-Cas OS 3.6 in hopes of a turnaround. It failed, and the calculator doesn't get past the spinning clock. That is it's current state.

Launch the diagnostic menu and then reboot, it will solve all your problems.

How Exactly?

Hold down the reset button and + + at the same time. While holding these down, release the reset button.

Nevermind, I figured it out. Thank you!

what i need to do next

What are you trying to achieve ?