Forum TI-Planet.org

Hello,

I use a TI NSPIRE CAS + CRADLE and different VERNIER SENSORS , the last time I had to log for 24 hours a room for the Humidity and Temperature. This work great even with the cradle in Stand Alone , but I would like instead of seconds to see the time.
I know that the nspire do not have a clock , but if I key in the time that I start the test , this will be OK , to see where or at what time something was going wrong.
Now I just calculate the seconds in hours, but it will be fine if I can read the time of the event directly.

Any other idea is welcome

Best Regards,
Didier

Hi,


The Vernier app just creates 2 lists: time and values.

You could just store those lists in 2 other variables and use them in another TI-Nspire app.
The time-list could then be modified in many ways:
- converted to minutes or hours
- added the initial time
- ...

Did I answer your question?


Critor

Hi,

I will give it a try , do you think the new values will be visible in the graph ?

Thank You for your help , I will keep you informed

Best Regards,
Didier